Lynn Haven Baptist Church
Cleaning, rust-inhibiting primer, sealed fasteners and seams, and a restoration coating

Project Overview
Lynn Haven Baptist Church is at 1501 East Washington Avenue in Vinton, just outside Roanoke. The main building is brick with a large metal roof, along with lower roof sections and a covered walkway.
The metal roof had rust, leaking screws and a long history of patch repairs. The church needed the leaks stopped and the roof protected, without the cost of replacing the metal. We completed the restoration in 2025.
Job Photos
The Challenge
Exposed-fastener metal roofs are held down by thousands of screws, each with a rubber washer. Over time those washers dry out and crack, and the screws back out as the metal expands and contracts. That is a common source of leaks, and it was one here.
Rust on the panels and a lot of past repairs added to the problem. Patches from earlier repairs can hide rust and make it hard to tell what is actually sealed and what is not.
Our Solution
We restored the full roof. We cleaned it thoroughly, applied a rust-inhibiting primer, sealed every screw, fastener and seam, and then applied a restoration coating over the whole roof.
- 1We cleaned the metal roof thoroughly.
- 2We applied a rust-inhibiting primer to the metal.
- 3We sealed every screw and fastener.
- 4We sealed the seams.
- 5We applied a restoration coating over the full roof.
Why This Approach
When metal panels are still structurally sound, a restoration addresses the actual causes of leaks, the fasteners, seams and rust, for much less than replacing the roof. Priming stops rust from continuing under the coating. Sealing each fastener and seam closes the leak points one by one, and the coating ties it all together into a protective layer that also reflects sunlight.
Results
- Full cleaning of the metal roof
- Rust-inhibiting primer applied
- Every screw, fastener and seam sealed
- Restoration coating over the full roof
Common Questions
Why do screws on a metal roof leak?
Each screw seals with a rubber washer. Sun and weather dry out and crack the washers over time, and expansion and contraction of the metal can loosen the screws. Restorations seal or replace those fasteners before the roof is coated.
Is restoring a church metal roof cheaper than replacing it?
In most cases, yes. If the panels are structurally sound, a restoration that treats rust, seals fasteners and seams, and coats the roof costs much less than new metal, with less disruption to services and events.
Need a Similar Solution?
Contact us today for a free inspection and consultation on your commercial roofing project.



